COMPUTER INPUT: Analog RGB/YPbPr on HD15 connectors into 75Ω,
supporting RGBHV, RGsB, YPbPr, auto-terminating into 75Ω Digital sync (in RGBHV mode): TTL Level, 10K termination, pos or negative
Analog sync (in RGsB, YPbPr, YUV modes): 0.3V negative.
RGB Level Range: 0.5-2.0 Vpp
Scan Rate Detection: automatic
PC Resolutions: any up to 2048x2048
HDTV Resolutions: any up to 1080p
Max horizontal scan rate: 150kHz
VIDEO INPUTS: Composite video on BNC connectors
S-Video (YC) on 4-Pin mini-DIN Connectors
CV/YC video decoder: 8-bit Digital Input impedance: 75 Ω
Television standards supported: NTSC and PAL
De-Interlacing (NTSC / PAL): pixel-level motion adaptive Comb filter decoding: adaptive Film mode (NTSC) 3:2 pull down
CV/YC Video adjustments: contrast, brightness, saturation, hue (NTSC)
CV/YC sub-carrier lock range: +/- 200Hz (NTSC), +/- 250Hz (PAL)
VIDEO OUTPUTS: Composite Video 1Vpp on BNC connectors
S-Video (YC) 1Vpp on 4-pin mini-DIN connectors CV/YC Video encoder: 8/10-bit Digital Output impedance 75Ω Television standards supported: NTSC and PAL.
COMPUTER OUTPUTS: RGBHV loop
YPbPr (0.7V RGB / 1.0V sync-tip to white, approx. 0.4V DC offset)
HDTV Resolutions: any up to 1080p
Vertical Refresh Rate: any to 250Hz
CONTROL METHODS: The unit can be controlled locally via the front panel buttons and on-screen display (OSD), remotely via the RS-232 interface using a D9 female connector or again remotely via the Infrared remote using the infra-red remote unit.
SCALING / SAMPLING / MEMORY: Size and position: automatic via AutoSet or Manual.
Image size: user-definable presets.
Image freeze: one video frame.
Settings memory: non-Volatile.
Zoom range: variable to 10x Zoom (1000%).
Firmware memory: flash, upgradeable via RS-232
LOCKING/MIXING: CV/YC SC/H phase adjustments: +/- 180 degrees (for units with CV/YC output only)
Keyer: chromakey (YUV) or lumakey (Y)
Mixer: PC / Video, foreground/background swappable PIP: variable window size & position – single-button enabling
(Not all locking/mixing combinations are available: you cannot overlay one CV or YC source over a different CV or
YC source, or one RGB/YUV source over another RGB/YUV source – you are restricted to overlaying CV/YC over RGB/YUV, or RGB/YUV over CV/YC (the exception is where
you can overlay one source over itself).
POWER REQUIREMENT: External power supply: 12V DC @1A maximum.
Actual current consumption varies between units. Internal over-voltage & over-current protection. Full PSU specification: 12V DC regulated 1Amp PSU with a 2.5mm locking center-pin positive DC power connector. A non-locking 2.5mm DC power connector will also fit.